Give a heart from the heart with this beautiful valentine pop up.
Cardstock or construction paper
Crayons, colored pencils or Markers
Click on printables and print out the heart and card pages on a heavy paper, like card stock or construction paper. Remember if you want to make a larger card and have access to an enlarging copy machine, just be sure to enlarge them both at the same percentage.
Using a ruler as a guide, take the rounded end of a paper clip (or a ball point pen that has run out of ink) and press along the dotted lines of the heart print-out.
Cut the heart print-out from the sheet by carefully following the solid, black lines around the edges... until the pop-up piece is removed.
Flip the pop-up piece OVER so the dotted lines are not visible.
Lay the pop-up piece on a flat surface and take hold of the right side.
Carefully fold the entire right side over onto the left side and crease it flat.
Take hold of the smaller heart at the left...and carefully fold it all the way over to the right, creasing it flat.
Flip the entire pop-up piece over.
Take hold of the smaller heart at the right and fold it all the way over to the left, creasing it flat.
Open the pop-up piece and COLOR your pop-up with colored pencils or crayons. Set the pop-up piece aside.
Using a ruler as a guide, take the rounded end of a paper clip (or a ball point pen that has run out of ink) and press along the dotted line running down the center of the card print-out.
Cut the card from the sheet by carefully following the solid, black lines around the edges.
Fold the card in half along the dotted lines to crease it, then open it again.
Apply white glue to each heart printed on the left and right sides of the card.
Place the two smaller hearts of the pop-up piece over the glue areas on the card and carefully press down letting the glue dry.
After the glue has dried carefully close the card.
Your pop-up Valentine is finished! Now give it to that special someone!
This craft reprinted courtesy of Robert Sabuda.