Styrofoam Brand Productshttp://craft.dow.com/index.htm
Who says pumpkins have to be crafted as big round balls. Take a look at these cone shaped smiling pumpkin faces and you will discover a whole new world.
STYROFOAM* Brand Cones:
Assorted 4", 6", and 9" for pumpkin faces;
6" for poseable pumpkin
Orange crepe paper streamer
Dark green floral tape:
1/2" width for pumpkin faces;
1" width for poseable pumpkin
Solid black scrapbook paper
White craft glue or glue stick
Small green velveteen leaves (optional)
Additional Materials for Poseable Pumpkin:
24-gauge aluminum wire
1/4" black bead for nose
Matte decoupage medium
Medium flat paintbrush
For each pumpkin face, push end of crepe paper streamer into center bottom of cone with a wooden skewer and glue to secure. Wind crepe paper around cone to cover, overlapping edges 1/2". Gently stretch lower edge of streamer as you wrap to achieve a smooth surface. Note: If paper tears, tape torn edge to foam and then glue new end of crepe paper over it. Hold your thumb over this area as you wrap until secure.
Trim crepe paper at top of cone. Push end into tip of foam and glue.
Wrap top of cone with floral tape, gently stretching tape to promote adhesion. If desired, tape stems of velveteen leaves to top of cone at same time (refer to photo). Continue wrapping tape a short distance above foam to form a stem. Curl top by wrapping tape around itself a few times, trimming, and then twisting the end until it curls back onto itself.
Using photo as a guide, cut facial features from black paper and glue to cone pumpkin. Vary faces for added interest.
Follow Steps 1-2 to cover cone with crepe paper. Apply a coat of decoupage medium to entire cone and allow to dry. Note: Wrinkles in wet crepe paper will smooth out as medium dries.
Follow Step 3 to wrap top of cone with floral tape and form a thin straight stem.
From wire, cut two 6" arms and two 6" legs. Form a 1/2" loop at one end of each leg for a foot, twisting wire to secure. Wrap arms and legs (including feet) with floral tape.
Click on Printables and using pattern, cut four leaves from 1" dark green floral tape. Adhere a leaf near one end of each arm for hands and anywhere on each leg.
Tightly twist a 4-1/2" length of floral tape, leaving 1-1/2" untwisted at one end. Continue twisting until tape curls back onto itself. Tape curled vine to an arm (refer to photo). Add additional vines to arms and legs as desired.
Glue and insert arms and legs into cone pumpkin (refer to photo). Bend wires to pose as desired.
Using photo as a guide, cut eyes and mouth from black paper and glue to cone pumpkin. Cover nose bead with a small square of floral tape, gathering edges of tape at back and twisting tightly. Poke a small hole in pumpkin to attach nose. Squeeze glue in hole and then push twisted tape portion of nose bead in hole with a wooden skewer.