Transmenu powered by JoomlArt.com - Mambo Joomla Professional Templates Club

This craft reprinted courtesy of Terri of MakingFriends.com.

No more struggling with coiled pins! Larger sized "E" beads make beaded butterfly pins easier for kids.

Coiless Safety Pins - 2¼"
4mm Round Beads
"E" Beads
Safety Pins, Size 2
Long-Nose Pliers

Each row hanging down is a size 2 pin with "E" beads strung on it. Open these pins and string beads following the pattern chosen. Keep in mind that you are stringing the beads upside-down so you will start at the top with of each row and work down. Then turn the pin upside-down. Use pliers to squeeze the pin head closed permanently.

Note: Glass beads are are irregular in size. You will not be able to use the larger "E" beads in your package. It may look like the pins will not close but as long as the tip shows, you can usually just press the point into the pin head opening. The pin will bend out slightly to fit the beads snuggly into place.

Open up the coiless pin. You will need to bend it open to at least a 60 degree angle to get the beads on. Beginning with the beaded pin to the far right, thread the coil of that beaded pin onto the coiless pin, around the bend and over to the head of the pin. Slide on a 4mm bead. Then the next beaded pin, followed by another 4mm bead. Continue until you have threaded on all pins and finished off with a final 4mm bead. These beads help hold the pins in place and keep them from sliding around the coiless pin.

Terri Bose of MakingFriends.com http://www.makingfriends.com/ Terri is the creator of makingfriends.com, freekidscrafts.com, scoutswaps.com and badginabag.com. Her work is republished all over the internet and is considered the queen of kids crafts.